Table of Contents
Advertisement
8/31/22, 1:52 PM
Printer: 24VDC, 3.75A, 90W
With Adapter: 100-220 VAC, 50/60Hz, 2A
Power for the printer must be on a surge-protected circuit. UPS (Uninterruptible Power Supply) usage, while not
required, is recommended in areas where power uctuations are frequent, as surges and spikes can cause damage
to electronic components, and loss of power can result in failed builds or potential damage to the FabPro
system. For speci c information on a suitable UPS, contact a UPS manufacturer and provide the voltage rating,
current draw, and desired backup time. The manufacturer can recommend an appropriate model.
Connection to AC Power
In the United States, a standard 10-amp wall outlet is required. The system connects to a 110VAC power outlet through
a standard 110VAC power cord.
In Europe, a standard 10-amp wall outlet is required. The system connects to a 220VAC power outlet through a
standard 220VAC power cord. Country destination kits are available with the proper wall-power connections.
Part 2
Heat Dissipation
The printer is not expected give off signi cant heat under normal operating conditions.
Temperature
The temperature in the room or location where the FabPro system resides should remain stable to allow for
optimal system operation and optimal part quality.
FabPro™ and NextDent materials should be kept between 18°C-28°C (64.4°F-82.4°F)*. Since there is material in
the print tray, this guideline applies also to the temperature of the room the printer is in. Be sure to follow the
temperature speci cations set forth in your material's Instructions for Use/SDS.
*For Figure 4 FLEX BLK 10 print material, printing temperatures outside the range of 10-30°C (50-86°F) can cause
printed-part properties to change.
Humidity
The optimal humidity in the printer build chamber and lab will depend to a certain degree on the FabPro/NextDent
material selection. Regardless, the humidity should always be non-condensing and should not vary outside the
range of 30 to 70% RH*. Review your FabPro/NextDent material information (SDS, product datasheet, and product
labeling) for speci c information on recommended humidity levels.
*For Figure 4 FLEX BLK 10 print material, humidity outside the range of 10-65% RH can cause printed-part
properties to change.
Altitude
The FabPro system is capable of operating correctly up to an altitude of 3000m (9843 ft.) above mean sea level.
Overall Sound-Pressure Level (OASPL)
The sound of the FabPro system will not exceed 85 db.
infocenter.3dsystems.com/fabpro1000/print/book/export/html/526
®
User Guide
30/111
Advertisement
Table of Contents
