Table of Contents
Advertisement
8/31/22, 1:52 PM
Troubleshooting
There are unique situations you may encounter when operating the printer. This section has compiled a partial list
of these situations and methods of troubleshooting them.
NOTE: Unless troubleshooting steps require the printer to operate, shut down the printer and unplug it
before performing troubleshooting steps.
Print Failures
#
Issue Description
1
Supporting architecture not
generating properly during
part building
infocenter.3dsystems.com/fabpro1000/print/book/export/html/526
User Guide
Customer Troubleshooting Steps
This can be caused by:
1. Not enough material in the print tray. To prevent this, be sure to ll material
back up to the minimum level speci ed in this guide before building.
2. Cold material. Be sure the room where you store material and the room
you print at is kept within the temperature limits expressed in this manual.
If you have taken both of these steps and still have issues printing
supports, please contact your authorized print-material provider.
87/111
Advertisement
Table of Contents
