3D Systems FabPro 1000 User Manual page 59

8/31/22, 1:52 PM
NOTE: If this is the rst time you have used the printer, you will see a message on the printer screen asking
you to activate your printer. In 3D Sprint, ll out your information and click Submit.
1. Once you have sent the job to the printer, you will see the
message at the right on the printer.
continue.
2. You will see the screen at the right.
and the printer will look to see if a build le was sent to it.
3. The printer will display the name of the le you sent from 3D
Sprint. If the lename is longer than 20 characters, it will scroll
across the screen to show you the complete name.
4. Hold down the power button to con rm you want to print the le.
5. The printer will verify the build le and then you will see the screen
at the right. Retrieve the material bottle you wish to use for this
print job.
. Hold the bottle's QR code under the QR-code scanner. Wait until
you see the message at the right before pulling the bottle away
from the scanner. Please see the gray box below for other
messages you might receive when scanning a material bottle.
infocenter.3dsystems.com/fabpro1000/print/book/export/html/526
User Guide
Press the power button to
Hold down the power button
Printer Message Translation
Printer
ready
[IP
Address]
Print job
Hold
button to
continue
My-print-
job.pxl
Hold
button to
continue
Please
scan
material
cartridge
Add
material.
Hold
button
to continue
59/111