Table of Contents
Advertisement
8/31/22, 1:52 PM
Important Safety Information
CAUTION: IMPORTANT SAFETY INSTRUCTIONS – READ AND FOLLOW THESE INSTRUCTIONS BEFORE
OPERATING PRINTER.
Introduction
You must read all manufacturer documentation before operating the printer. Also, anyone assisting you must have
also read the documentation. After reading all the manuals, always follow the safety guidelines and procedures in
this section when operating the printer.
Customer Safety Program
Before using the printer, customers must have a safety program in place. The safety program should do the
following:
Label and point out hazardous equipment, materials, and procedures.
Explain what to do in an emergency situation.
Provide information about the hazards of equipment and materials in the form of Safety Data Sheets (SDS). The SDSs
are provided with all print materials supplied by 3D Systems.
The information in this chapter supplements the customer's existing safety program. It points out safety
considerations that speci cally concern the printer.
Levels of User
WARNING: DO NOT ATTEMPT TO PERFORM ANY PROCEDURES DESCRIBED IN THIS MANUAL UNLESS
YOU HAVE READ THROUGH THE ENTIRE MANUAL FIRST.
There are two levels of users of the printer, based on the amount and type of training the user has received. The
two levels of users (operators and depot repair personnel), are described below.
Operator
Those who have purchased the printer and have read all printer manuals. The operator may print a 3D part and
perform simple printer service tasks, as outlined in this guide. Operators 18 and under must be supervised.
Certi ed Service Personnel
Certi ed service personnel are those who have completed the 3D Systems service training package, and are
certi ed to perform service tasks on the NextDent 5100 Printer. Certi cation may occur at various levels, and
certi ed service personnel should only perform tasks they are authorized and certi ed to complete.
Safety Design Features in the Printer
The following design features are provided to reduce potentially hazardous operating conditions:
WARNING: IF ANY OF THE FOLLOWING SAFETY FEATURES FAILS, YOUR ACTIONS MAY BE ALL THAT
WILL PREVENT POTENTIALLY HAZARDOUS OPERATING CONDITIONS.
The design of the UV-delivery system is intended to prevent UV radiation from being aimed outside the area of the build
chamber.
infocenter.3dsystems.com/fabpro1000/print/book/export/html/526
User Guide
4/111
Advertisement
Table of Contents
