Table of Contents
Advertisement
8/31/22, 1:52 PM
2. After cleaning, be sure that the base is completely dry
before inserting it back into the machine, so as not to
contaminate the printer with cleaning solvent. Dry it
with shop air or micro ber cloth.
3. When reinstalling the plate in the machine, be sure that
the base is secure and inline with the at guides on all
four corners.
Remove/Replace Catch Tray
Remove the Catch Tray
You will have to empty the catch tray whenever there is a material spill into it.
NOTE: Be sure that you remove the print tray and glass print base prior to performing this procedure.
1. Have a washing tub and recommended solvent on-hand. The tub
should be big enough to submerge the whole catch tray if need be.
CAUTION: Do not empty or wash the catch tray in a sink or
other tub that drains into wastewater. The uncured print
material inside must be disposed of according to all local,
state, and federal regulations.
infocenter.3dsystems.com/fabpro1000/print/book/export/html/526
User Guide
Glass lines up with at guides on all four corners
82/111
Advertisement
Table of Contents
