3D Systems FabPro 1000 User Manual page 102

8/31/22, 1:52 PM
2. Place the outer box (1) over the printer and
base packaging.
3. Place packing foam (2) over the printer in the
orientation shown at right. One piece should go on the
front of the printer and the other piece should go on the
back of the printer.
CAUTION: Altering the orientation of the box
and packing foam from what is seen in this
guide could result in irreversible damage to
the printer.
4. Repack the nishing kit in the optimized orientation
seen at the right. Please see the section
Printer for information on which part each letter is
referring to. Seal the nishing kit.
5. Place packed nishing kit (a), along with with power cord box (c) and packed-in documents (b), in the orientation
shown.
5. Place the power cord inside the power-cord box (item "c," above).
infocenter.3dsystems.com/fabpro1000/print/book/export/html/526
User Guide
Unpacking the
102/111