Motor Diagnostics - 3D Systems FabPro 1000 User Manual

8/31/22, 1:52 PM
can enter this mode whenever the printer is powered on and in idle mode (not printing).
Open Printer Diagnostics
Press the power button
screen.
In this dialog, you can access the following diagnostics and sub-diagnostics:

1. Motor Diagnostics

a. Elevator Diagnostics
b. Tilt Motor Diagnostics
2. Barcode Scan Diagnostics
3. Projector Diagnostics
Motor Diagnostics
This diagnostic exists to test both the elevator motor and tilt-tray motor. You will need to test the elevator motor if,
for example, the print platform does not move to its proper o oad position after printing. You will need to test the
tilt motor if, for example, printed parts are not peeling off the print-tray lm properly.
CAUTION: You must remove the print tray and print platform before beginning this process. Failure to do
so risks damaging the printer.
CAUTION: Do NOT put your hands, or any other object, inside the printer during motor diagnostics.
NOTE: It is best to have the printer door open during diagnostics in order to watch the elevator motor and
tilt motor go through their motions.
Elevator Diagnostics
1. On the Printer Diag screen,
button to get to the
2. On the Motor Diag screen,
once more to get to the
3. On the Elevator
button to enter the diagnostic.
infocenter.3dsystems.com/fabpro1000/print/book/export/html/526
twice to enter the "Printer Diag"
hold down the power
Motor Diag screen.
hold down the power button
Elevator Diag screen.
Diag screen, hold down the power
User Guide
Printer Message
Printer Message
Translation
Printer Diagnostics
Hold button to
continue
Translation
Printer Diagnostics
Hold button to
continue
Motor Diagnostics
Hold button to
continue
Elevator Diagnostic
Hold button to
continue
93/111