Table of Contents
Advertisement
8/31/22, 1:52 PM
1. Insert USB drive into the USB port on the left side of
the printer. You will see the message at the right. You
may cancel the job submission at this point by
pressing
the power button once.
button to con rm job cancelation.
2.
Hold down
the power button to detect print jobs on the
USB device.
3. If the printer does NOT detect build les, you will see
the screen at the right. Please try loading your build
les onto the USB again. You may cancel the job
submission at this point by
once.
Hold down
cancelation. If the printer does detect build les, skip to
Step
4.
4. If the printer detects build les, you will see a
message like the one at the right on the printer
screen, with your build le's name on the rst line. If
the lename is longer than 20 characters, it will
scroll across the screen to show you the complete
name. At this point:
a.
Hold down
le on the printer's memory.
b.
Press
le and look for the next le on the USB device.
Repeat this process until you have found the
print job you wish to submit.
power button to submit the print job.
c. If you go through the whole list of print jobs
on the USB device without selecting one, you
will see the message at the right on the
printer screen. Holding down the power
button at this point will bring you back to the
printer's
NOTE: The maximum storage the printer has for
build les is 1GB.
infocenter.3dsystems.com/fabpro1000/print/book/export/html/526
Hold down
pressing
the power button
the power button to con rm job
the power button to load this build
the power button to skip over this build
Hold down
Idle
screen.
User Guide
the power
the
Submit job via USB?
Hold button to
continue
Cancel USB submit?
Hold button to exit
No jobs detected
Hold button to exit
myprintjob.pxl
Hold button to
continue
End of jobs list
Hold button to exit
63/111
Advertisement
Table of Contents
