3D Systems FabPro 1000 User Manual page 64

8/31/22, 1:52 PM
5. If you submitted a build le in Step 4a, this will begin
the printing process. You will see the screen at the
right.
. Continue with Step 4 from the previous section
via 3D Sprint.
Abort the Print Job
You may manually abort the print job at any time during the build.
1. Press the power button once. You will see the
message at the right on the printer screen.
2. Hold down the power button to con rm print job
cancelation.
HARMFUL IRRITANT WARNING: AFTER ABORTING THE PRINT JOB, YOU MUST DISPOSE OF THE
PARTIALLY PRINTED PART AS YOU WOULD ANY UNCURED MATERIAL AND ACCORDING TO ALL LOCAL,
STATE, AND FEDERAL REGULATIONS. ALWAYS HANDLE THE PARTIALLY CURED PART AND THE PRINT
PLATFORM WITH 100% NITRILE GLOVES. CLEAN THE PRINT PLATFORM AS YOU WOULD AFTER ANY
PRINT JOB.
Print Tray Material Cross-Usage
You may clean the print tray with recommended solvent between builds, enabling you to use different materials in
the same print tray (not at the same time). However, since residual elements of print material cannot be reliably
fully removed from the print tray, there are only certain materials that may be swapped out per individual print tray.
The chart below shows which materials can share the same print tray. Mark your print trays with letters, numbers,
or other notations to help you remember which tray is which.
Tray 1
NextDent Surgical ®
Guide
NextDent Model ®
NextDent Ortho ®
Rigid
Stir the Material
Before printing with all materials, you must mix the material bottle on the
again with those materials, you must stir the material in the print tray using the
section. The chart below describes each compatible material's requirements for: bottle mixing time, stirring time in
infocenter.3dsystems.com/fabpro1000/print/book/export/html/526
Print
Tray 2 Tray 3
NextDent ® FabPro™
Model 2.0 Proto
GRY
User Guide
Printer Message
Tray 4 Tray 5
FabPro™ FabPro™
JewelCast Tough
GRN BLK
NextDent
Resin
Job ready
Hold button to start
Translation
Abort job?
Hold button to abort
User stopped print
Aborting
Tray 6 Tray 7
FabPro™ FabPro™
Elastic Flexible BLK
BLK
® LC-3DMixer. Before printing
Mixer, as seen in the next
64/111