Install Print Platform - 3D Systems FabPro 1000 User Manual

8/31/22, 1:52 PM
10. Open printer door. Remove foam from underneath the tilt tray.
11. Connect power cord and adapter together and connect to printer. Plug
adapter into wall outlet.
12. If you wish to send jobs to the printer over a network, connect the
Ethernet cable to the printer. WiFi connection to the printer is not
available.
CAUTION: Printer weighs 37.5kg (82.7 lbs). Please be careful, and use proper lifting techniques, as well
as the help of another person, to avoid injury.
CAUTION: Do not install the printer near direct sunlight or other strong UV source. If the print material is
exposed to direct sunlight, the material will begin to cure. Standard uorescent lamps with clear plastic
diffusers are recommended to minimize ultraviolet exposure. Sunlight, quartz-halogen lamps, and high-
intensity incandescent lamps are not suitable. UV lters are available for windows and exposed
uorescent lamps.
CAUTION: Install the printer on a sturdy, level surface. Do not install it in a place where it will straddle
table/counter/desk seams. If at all possible, install in a ground- oor room with a concrete base. Do not
install over or near carpeted areas or other porous surfaces such as hardwood. These precautions exist
to maintain the integrity of your 3D-printed builds and for safety in the event of a material spill.

Install Print Platform

ALWAYS WEAR NITRILE GLOVES WHEN HANDLING THE PRINT PLATFORM, AS IT COULD HAVE
UNCURED MATERIAL ON IT THAT COULD IRRITATE THE SKIN.
NOTE: Before performing this procedure, ensure that elevator is at its upper limit, or o oad, position.
infocenter.3dsystems.com/fabpro1000/print/book/export/html/526
User Guide
48/111