Table of Contents
Advertisement
8/31/22, 1:52 PM
NOTE: Instead of using the bottle mixer, you may opt to mix the material bottle by hand, shaking it
vigorously in an up-and-down motion. Shake it for ve minutes for a new material or for one you are
treating as new (see above note). Shake the bottle for two minutes for a recently used bottle. Please see
the section
material. This technique will not su ciently mix the material.
NOTE: Ensure that you place the build in your UV curing oven in the same orientation it was printed in, as if
the bottom of the oven is the print platform.
Resin Mixer
Material that is left in the print tray between builds needs to be stirred periodically with the Resin Mixer. Refer to the
Material Stirring and Curing
materials.
CAUTION: Failure to su ciently mix materials before each build may result in color deviation and/or print
failure.
CAUTION: Ensure that the mixer is clean before each use. To clean the mixer, wipe it with a nonabrasive
cloth and the recommended solvent.
1. Run the mixer through the material, with the sharp end (1)
facing down. Grip the mixer on the indented gripper (2). Do this
for ve minutes. Please see the images below for the proper
stirring technique.
Do not move the Resin Mixer's blade across the print-tray
lm like a knife. Rather, move it up and down similar to
using an ice scraper.
infocenter.3dsystems.com/fabpro1000/print/book/export/html/526
Begin Your Print Job
for more information. You MAY NOT hand-mix NextDent Model 2.0
Chart and/or your material's Instructions for Use for information on stirring print
User Guide
66/111
Advertisement
Table of Contents
