Table of Contents
Advertisement
8/31/22, 1:52 PM
Cleaning Solvent - Cleaning solvents are used in cleaning printed parts, printer components, and areas where
material has spilled. Please refer the
Safety Glasses (405 nm radiation blocking) with side shielding - The printer operator should not be exposed to
hazardous radiation from the printer or curing oven. However, in the case of an emergency where radiation emits
from these devices, it is recommended to wear eye protection.
NextDent LC-3DPrint Box - Please see the section
®
®
NextDent LC-3DMixer - Please see the section
Ultrasonic Cleaner - Used to clean excess liquid material off the printed part before nal UV curing. Order this from
your local supply house.
System Installation
Installation of your system encompasses three separate steps:
1. Purchase and arrival of third-party equipment or supplies you may have ordered.
2. Delivery of your FabPro system shipment.
3. Unboxing and installation of your FabPro system components.
System Unboxing
Please see the section
Preparing for System Installation
In preparing your facility for FabPro system placement, you must consider three main factors:
Make sure that you have the necessary doorway and passageway clearance to move either the boxed or
unboxed components to their nal destinations.
Make sure that you have another person to help team-lift the system up to its staging area, boxed or unboxed.
Be sure that the desk/countertop/table the printer is staged on can handle the weight load of the printer and other
ordered components. Please see the section
Minimum Passageway and Door Openings
Most standard doorways and hallways provide adequate access for moving the system. Each doorway and
hallway must be wide enough to move and turn a box measuring 62 x 62 x 101 cm (24.5 x 24.5 x 39.75 in), while
also allowing room for the people carrying it. Determine the pathway from where you will receive the boxed
components to where your FabPro system will be installed. Walk this path, and measure any critical doorways or
passageways to ensure that the equipment can be moved through the area. If a passageway or doorway is too
small for the boxed FabPro system, it may be necessary to remove the FabPro system from its box before moving
the unit. Since the printer is only 61.2 cm (24.1 in) high, the height limitations of most any door will not be an issue.
Considerations for Material
You are responsible for ensuring that the facility where your FabPro system and print materials are housed is
properly con gured for safe operation of the printer system and of the materials used in that system. Personnel
who operate the equipment or use the materials must comply with all relevant safety codes and applicable
infocenter.3dsystems.com/fabpro1000/print/book/export/html/526
Cleaning Chart
LC-3DMixer
Unpacking the
printer.
Weights and
User Guide
to determine which solvent(s) to order.
LC-3DPrint Box
for more information.
for more information.
Measures for more information.
36/111
Advertisement
Table of Contents
