Table of Contents
Advertisement
8/31/22, 1:52 PM
Test Scan
These are messages that may occur during operation of Test-Scan Diagnostics. For more information, please see
the section
Test
Scanner.
Printer Message
Test Projector
These are messages that may occur during operation of Test Projector diagnostics. For more information, please
see the section
Test
Printer Message
infocenter.3dsystems.com/fabpro1000/print/book/export/html/526
Warning
Moving tilt motor
Diagnostic complete
Elevator error
Diag complete
successfully
Diagnostic complete This message occurs when the
Translation
Scan test barcode
Hold button to
continue
Scan test
failed
Scan test
complete
Projector.
Translation
Testing projector
Projector test
failed
Projector test
successful
User Guide
This message occurs when the printer's tilt motor is
moving during Tilt Motor Diagnostics.
This message occurs when the elevator does not hit its
upper and lower limits during testing.
button to clear the error.
This message occurs when the
completes successfully.
completes, whether successfully or not.
This message occurs after you hold down the power button
on the
Test Scan
screen.
This message occurs if the scanner is unable to read the
test barcode.
Press
the power button to clear the error.
This message occurs if the scanner successfully reads the
test barcode.
This message occurs after
on the
Test Projector
screen.
This message occurs when the printer does not register an
acceptable power output from the projector.
power button to clear this error.
This message occurs when the printer registers an
acceptable power output from the projector.
Press
the power
Elevator Diagnostic
Tilt Motor Diagnostic
holding down
the power button
Press
the
110/111
Advertisement
Table of Contents
