Table of Contents
Advertisement
8/31/22, 1:52 PM
1. Install the print platform in the machine, using the guides on either end
of the elevator platform to guide the print platform into place.
2. Push down the handle to lock the print platform in place.
NOTE: The printer checks if the print platform is present
and if the handle is locked down. The printer will not print
unless both conditions are met. If either condition is not
met, you will receive the error message below before the
print process begins.
CAUTION: Do NOT lift up the locking handle during
printing. Doing so will abort the print job.
Install Print Tray
1. Ensure the glass print base is clean and install it in the printer,
being sure to line up the at corners of the print base with the
at parts of the corner brackets in the tilt tray.
WEAR 100% NITRILE GLOVES WHENEVER HANDLING
PRINTER COMPONENTS. THIS IS TO BOTH PREVENT
MATERIAL FROM GETTING ON YOUR HANDS
AND PREVENT TRANSFER OF DIRT AND OIL FROM
YOUR HANDS TO THE PLATE. FINGERPRINTS AND
DEBRIS ON THE PLATE CAN INTERFERE WITH THE
LIGHT PROJECTED BY THE PRINT ENGINE AND
RESULT IN FAILED BUILDS.
2. When inserting the print tray into the tilt tray, ensure
that the FRONT label is facing forward.
infocenter.3dsystems.com/fabpro1000/print/book/export/html/526
User Guide
49/111
Advertisement
Table of Contents
