Table of Contents
Advertisement
8/31/22, 1:52 PM
5. On the damaged printer, or on the printer you are
transporting, pour recommended solvent onto a
nonabrasive cloth and wipe down all interior printer
surfaces, even if it seems there is no material on them.
Use the following as a checklist for cleaning the inside
of the printer:
Door
1
Left Wall
2
Back Wall
3
Ceiling
4
Right Wall
5
Tilt Tray
6
Chassis
7
. On the damaged printer, or on the printer you are
transporting, examine the elevator (1). Pour
recommended solvent onto a nonabrasive cloth and
clean the elevator
CAUTION: Pour solvent onto
the nonabrasive cloth rst, and then wipe
down components. For components that
cannot come out of the printer, pouring
cleaning solvent directly onto them risks
dripping solvent onto unwanted surfaces.
7. If you are transporting your working printer, place
packing foam in between catch tray and print tray, as
shown (2). Close printer door.
NOTE: It is not necessary to place the
packing foam (2) inside a damaged printer
you are sending back. This is only
necessary when transporting the printer
with a print tray installed.
Disconnect All Cables
1. Disconnect Ethernet cable.
2. Unplug power cord from wall outlet and unplug power adapter from AC inlet on printer.
3. Connect the power cord/adapter to the new printer you received.
infocenter.3dsystems.com/fabpro1000/print/book/export/html/526
User Guide
100/111
Advertisement
Table of Contents
