Table of Contents
Advertisement
8/31/22, 1:52 PM
infocenter.3dsystems.com/fabpro1000/print/book/export/html/526
User Guide
User stopped print
This message occurs if you hold down the power
Aborting
button to con rm cancelation of a print job, as in
the message above. If you abort the print job, you must:
1. Remove the print platform from the machine.
2. Remove the printed part from the print platform, as in
the section
However, there is no need to clean, dry, or UV-cure a
canceled or crashed build part. Dispose of the canceled
build part according to all local, state, and federal
regulations. Clean the print platform with
recommended solvent.
Print aborted
This message occurs after a print has been aborted, but
before the operator pushes the power button to clear the
message.
Printer error
This message occurs when the printer stops a build
because of a build error.
Aborting
Printer aborting
This message occurs when the printer stops a build
because of an elevator error when homing the elevator.
Resetting elevator
Install and Lock
Occurs when the printer does not detect a print
Platform/Hold btn to
platform securely locked in the machine. When you see
continue
this message:
1. Install a print platform and lock it down by pushing
down the handle.
2.
Hold down
process, or:
3.
Press
as seen on the line below:
Hold btn
When you see this screen, you may:
to abort
1. Hold down the power button to abort the print job, or:
2. Press the power button once to get back to the "Install
and Lock Platform" screen seen on the line above.
Printing
You will see a screen like this during printing, showing you
how much time is remaining for the print job. The time
4H:10M remain
format for the timer is HR:MM.
Remove Printed Parts From
ALWAYS WEAR 100% NITRILE GLOVES
WHEN HANDLING A CANCELED OR
CRASHED BUILD PART.
the power button to continue the printing
the power button once to see the
Platform.
Abort
screen,
108/111
Advertisement
Table of Contents
