Table of Contents
Advertisement
8/31/22, 1:52 PM
The following paragraphs provide general rst-aid procedures and recommendations for protective equipment to
minimize the risks from print material exposure. If professional medical attention is necessary, take the Safety Data
Sheet (SDS) for the exact print material involved to the attending physician.
Skin Contact
Print material may cause sensitization by skin contact. It is irritating to the skin; repeated and/or prolonged contact
may cause dermatitis. Wear 100% nitrile gloves and lab coats to avoid skin contact. Should print material come in
contact with skin, wash thoroughly with soap and COLD water and immediately remove contaminated clothing and
shoes. If skin is irritated, get medical attention. Dry-clean contaminated clothing. Discard contaminated shoes and
leather products.
Eye Contact
High vapor concentration may cause irritation. Safety goggles should be worn to prevent accidental splashes of
print material into the eyes. If print material comes in contact with the eye, ush immediately with large amounts of
COLD water for 15 minutes. Avoid sunlight, uorescent light, and other ultraviolet light, and obtain immediate
medical attention. Eye-wash facilities and a rst-aid kit should be readily available and close to the print material.
Contact Lenses
If print material splashes into the eye when contact lenses are worn, ush the eye with water immediately. Verify
that ushing has removed the contact lens from the eye. Protect eyes from light and obtain immediate medical
attention. Discard contact lenses that come into contact with liquid print material.
Fume Inhalation
Inhaling fumes from print material may be irritating to the respiratory system. High atmospheric concentrations
may lead to irritation of the respiratory tract, dizziness, headache and anesthetic effects. If a person should inhale
printer fumes, bring the exposed person to fresh air. Perform CPR if required. If breathing is di cult, give oxygen
and obtain immediate medical attention for the person.
Safety Notice
CAUTION: Use of controls or adjustments, or performance of procedures other than those contained
in any o cial manual for this machine, may result in hazardous radiation exposure.
NOTE: Closed-projector products are not considered to be hazardous.
This machine incorporates an optical system which, by itself, may be hazardous. However, this machine
incorporates a protective housing and UV-protective viewing window in the machine design such that there is no
exposure or human access to the UV radiation generated by the projector during normal operation.
All service to the projector process machine, the embedded optical system, and other components requiring
removal of printer panels shall only be performed by 3D Systems Corporation service personnel, their authorized
agents, or personnel who have been service trained by 3D Systems Corporation.
UNDER NO CIRCUMSTANCE shall attempts be made by the user to operate the projector with access panels
removed that allow access to UV radiation. Labels are provided on the products that indicate hazards.
The projector should not be operated if any of the UV-protective windows is damaged or removed. Contact your
authorized print-material provider for replacement information.
Product Labels
infocenter.3dsystems.com/fabpro1000/print/book/export/html/526
User Guide
11/111
Advertisement
Table of Contents
