Table of Contents
Advertisement
8/31/22, 1:52 PM
Toggle Case
A
lm over the glass print base. The female ends of these locks are on the print tray. The males ends are on the tilt
tray.
Print-Tray Film
B
building
Glass Print Base
C
Tilt Tray
Toggle Case
A
lm over the glass print base. The male ends are on the tilt tray. The female ends of these locks are on the print tray.
Top of Tilt-Tray Elevator
B
part of the elevator.
Tilt-Tray Pivot Point
C
Glass Print Base
D
raised holder to set the glass print base on.
View Box
- Hole in the tilt tray that allows UV radiation through
E
Part Cleaning
After parts have nished building in the machine, it is necessary to clean them of any uncured material. The
nishing kit contains two plastic tubs (with lids) that are big enough to t the largest-possible build on the printer.
Please see the section
For more-automated cleaning, you may choose to purchase an ultra-sonic cleaner. You will need an ultrasonic
cleaner big enough to accommodate the parts you plan on printing. Placing a container with solvent in this
cleaner sends ultra-sonic sound waves through the solvent to agitate it. One solvent bath may be su cient to clean
the printed part; but it is better to clean a part twice. As with any solvent, it will become saturated and rendered
ineffective over time. You will need to dispose of the solvent according to local, state, and federal regulations and
ll the container(s) with fresh solvent. For more information on cleaning build parts with an ultrasonic cleaner,
please see the section
infocenter.3dsystems.com/fabpro1000/print/book/export/html/526
Locks - These four locks keep the print tray in place during part building, and also tension the print-tray
- Translucent lm through which UV radiation is projected onto the bottom of the material during part
- Tensions the print-tray lm on the lm's underside
Locks - These four locks keep the print tray in place during part building, and also tension the print-tray
- The tilt tray uses an elevator with a lead screw to control its motion. This block is the upper
- The point about which the tilt tray tilts
- Translucent plate that tensions the print-tray lm from the lm's underside. The tilt tray has a
Clean Printed Parts
- Introduction for more information.
Cleaning Parts With Ultrasonic
User Guide
Cleaner.
16/111
Advertisement
Table of Contents
