Table of Contents
Advertisement
8/31/22, 1:52 PM
Holding the mixer slanted, run it back and forth through the
2.
material, careful not to put too much pressure on the print-
tray lm. Do this for the time prescribed in the Material
Stirring and Curing Chart.
CAUTION: Putting too much pressure on the print-tray lm can dent or puncture the lm, rendering the
tray unusable. The lm cannot be replaced by itself; if the lm is damaged, the whole print tray must be
replaced.
CAUTION: Puncturing the print tray will force a full tray's worth of print material into the catch tray. Use
extra caution when handling a full catch tray.
CAUTION: If the print tray gets punctured, discard it in the same way you would other materials that have
been in contact with liquid material.
CAUTION: Take care not to slosh material out of the print tray while stirring. If this happens, you will have
to clean the parts of the printer that the material got on.
After stirring, allow the mixer to drip material back into the print tray and then wipe excess material off the
3.
mixer with a nonabrasive cloth.
4. Repeat this process before every print job.
CAUTION: Be sure to clean the mixer with IPA between uses. Failure to do so risks mixing unstirred
material or different material in with material currently in the print tray.
infocenter.3dsystems.com/fabpro1000/print/book/export/html/526
User Guide
67/111
Advertisement
Table of Contents
