Table of Contents
Advertisement
8/31/22, 1:52 PM
. Seal the outer box with packing tape, packing belts, and plastic if desired. Loop the
packing belts through the planks on the pallet.
Your New Printer Location
When determining the best place for your printer in your new location, please remember to follow the guidelines
outlined in the
Facility Requirements
Unpacking Advanced Exchanged Printer
If you are sending your printer back for advanced exchange, you will receive another printer in similar packaging to
what you received the original machine in. Please follow the instructions in the section
unbox your new printer.
CAUTION: You must retain all packaging from the replacement printer for reuse in repackaging your
damaged printer. Your damaged printer cannot be sent back in packaging other than that which is
provided with the replacement printer. Using other packaging risks further damage to the printer.
Inspect Exterior of Printer
After you have unpacked the printer, visually inspect the interior and exterior of it for any damage that might have
incurred during shipping. Notify your authorized print-material provider immediately if anything is evident at this
point. DO NOT proceed with the installation until you have discussed the damage with your authorized print-
material provider.
Verify Printer Operation
Run a test print to verify that your replacement printer is functioning normally. Do so as seen in the
Guide.
Repackaging Damaged Printer for Advanced Exchange
After you have received your advanced-exchange printer, have set it up, and have veri ed its operation, you will pack
up your damaged printer and send it back to your authorized print-material provider.
Items to Repack
infocenter.3dsystems.com/fabpro1000/print/book/export/html/526
User Guide
section of this guide.
Unpacking the Printer
to
Quick-Start
103/111
Advertisement
Table of Contents
