Table of Contents
Advertisement
8/31/22, 1:52 PM
Power Button
A
Front Panel
- Graphical User Interface for oven. This shows information about the lamps, the time left for curing, and
B
error messages.
Oven Lid
- Insert a printed part through this top opening. The lid has a safety interlock that stops the oven when the
C
lid is open.
Lamp Status
D
Instructions for Use for more information.
Timer
- Shows time remaining in curing cycle
E
Increasing Button
F
Decreasing Button
G
Program Button
H
Start/Stop Button
I
UV Lamp
- The oven comes with six 18W, 71-color lamps and six 18W, 78-color lamps. See the oven's Instructions for
J
Use for information on correct orientation of lamps.
Glass Plate
- Holds the printed part during curing
K
LC-3DMixer
Before pouring the material in the print tray, it is necessary to mix it before each use to obtain the best-possible
chemical mixture in the bottle. The recommended method of stirring the material is with the NextDent LC-
3DMixer. With this mixer, you can roll two bottles at once for a speci ed period of time. For information on material
stirring times, please refer to the
infocenter.3dsystems.com/fabpro1000/print/book/export/html/526
- Switches machine on/off
Indicators - These indicators will turn red when the UV lamp pair needs to be changed. See the oven's
- Increases operation time
- Decreases operation time
- Toggles between preset operation times of 10, 20, and 30 minutes
- Starts and stops oven operation
Material Stirring and Curing
User Guide
Chart.
®
18/111
Advertisement
Table of Contents
