3D Systems FabPro 1000 User Manual page 97

8/31/22, 1:52 PM
1. On the Printer Diag
button to get to the
2. On the Motor Diag
get to the Test Scan
3. On the Test Scan
to the Test Projector
4. On the Test Projector
button to begin the diagnostic.
5. You will see the screen at the right during the test. The
test will measure the projector's power output.
. Depending on the outcome of the test, you will see one
of the following screens:
a. If you see the "Projector Test Failed" screen, it
means that the projector is damaged in some
way. Call your authorized print-material
provider for assistance.
b. If you see the "Projector Test Complete"
screen, the projector is functioning normally.
Exit Test Projector Diagnostics
You may exit Test Projector Diagnostics by:
1. Pressing the power button any time before the
diagnostic begins.
a. Hold down the power button to exit.
2. Aborting the diagnostic that is currently running by
pressing the power button. You will see the screen at
the right.
a. Press
the right.
b. Hold down
infocenter.3dsystems.com/fabpro1000/print/book/export/html/526
screen, hold down the power
Motor Diag screen.
screen, press the power button to
screen.
screen, press the power button to get
screen.
screen, hold down the power
the power button to see the screen at
the power button to exit.
User Guide
Printer Message
Printer Diagnostics
Hold button to
continue
Motor Diagnostics
Hold button to
continue
Test Scanner
Hold button to
continue
Test Projector
Hold button to
continue
Testing projector
Projector test
failed
Projector test
successful
Translation
Exit menu?
Hold button to exit
Projector test
failed
Exit menu?
Hold button to exit
97/111