Table of Contents
Advertisement
8/31/22, 1:52 PM
2. Wearing nitrile gloves, grab the back of the catch tray with one hand,
and the front with the other. Lift the tray up (1) and then pull it slightly
toward the front of the printer, until it rests on the chassis (2).
ALWAYS WEAR 100% NITRILE GLOVES WHEN HANDLING
THE CATCH TRAY, EVEN IF IT APPEARS THERE IS NO
MATERIAL ON THE OUTSIDE OF IT.
CAUTION: Always hold the catch tray upright to avoid
spilling the material inside.
3. Slowly pull the tray out. Holding the tray with one hand, hold a lint-free
paper towel underneath with the other to catch any potential spilled
material.
4. Dispose of the print material in the tray according to all local, state,
and federal regulations.
CAUTION: Do NOT reuse the material in catch tray.
Doing so risks contaminating the material in the print
tray, which will lead to failed builds.
5. Wearing nitrile gloves, hold the catch tray in the tub you prepared and
wash it with recommended solvent and a nonabrasive cloth, such as
micro ber. Dispose of solvent/material mix according to all local,
state, and federal regulations.
. Thoroughly dry the catch tray with shop air or other method.
Replace the Catch Tray
Use the following instructions to reinsert the catch tray into the printer or to install a new catch tray.
WEAR 100% NITRILE GLOVES WHENEVER PUTTING HANDS INSIDE THE PRINT CHAMBER.
infocenter.3dsystems.com/fabpro1000/print/book/export/html/526
User Guide
83/111
Advertisement
Table of Contents
