2
IMPORTANT SAFETY INFORMATION
SAFETY SYMBOLS AND DEFINITIONS
Hot Surface Hazard: A hot surface is accessible in the vicinity of this sign or at the print jet . Avoid contact with
these areas . Hot surfaces can cause severe burns .
Caution: Indicates something may happen that could cause loss of data, damage to equipment, or could cause
personal injury .
Caution: Indicates a pinch point hazard that could cause personal injury .
SHOCK WARNING: INDICATES A POTENTIAL SHOCK HAZARD .
SAFETY GUIDELINES
•
Follow all safety rules in this section and observe all cautions and warnings in this guide .
•
Do not modify any safety features or make modifications to the CubePro. Doing so is prohibited and voids the warranty.
•
Use of print materials other than genuine 3D Systems components may void the warranty .
WARNING: HAZARDOUS MOVING PARTS . KEEP FINGERS AND OTHER BODY PARTS AWAY .
HOT SURFACE HAZARD: DO NOT TOUCH THE PRINT JETS DURING SETUP AND OPERATION . THE PRINT
JETS BECOME VERY HOT .
Caution: Read and follow all instruction prior to setting up the printer .
SHOCK WARNING: DUE TO RISK OF SHOCK, AVOID CONTACT WITH ALL INTERNAL ELECTRONIC
COMPONENTS .
WARNING: THE CUBEPRO SHOULD ONLY BE SERVICED BY AUTHORIZED SERVICE TECHNICIANS .
PRIOR TO ANY PART REPLACEMENT PROCEDURE, THE PRINTER MUST BE POWERED OFF AND
DISCONNECTED FROM UTILITY POWER .
HOT SURFACE HAZARD: WHEN PRINTING WITH ABS MATERIAL, THE INTERIOR (PRINT CHAMBER)
OF THE PRINTER WILL HEAT TO A PREDETERMINED TEMPERATURE . THE SURFACE OF THE PRINT
CHAMBER HEATER WILL BE HOT . AVOID CONTACT WITH THE PRINT CHAMBER HEATER AND NOTE THAT
OTHER COMPONENTS INSIDE THE PRINT CHAMBER MAY BE HOT .
To ensure safety, please exercise caution when operating your CubePro . Read and follow all safety precautions as outlined in this user
guide . Be careful when operating your CubePro to ensure proper printing and be mindful of and avoid hot surfaces .