Printing A Part; Home The Elevator - 3D Systems ProX 800 User Manual

PRINTING A PART

Now that you are familiar with the various screens within the User Interface, you are ready to print. Follow these basic steps to
print your first part.
NOTE: Ensure print pad is installed prior to printing a part . See
information .
1. If necessary, turn the machine on by ensuring that the printer is
plugged in, then turning the power disconnect switch to the ON
position. For the location of the switch, see the section
Printer - Inside View" on page
2. Press the Print3D Pro
application.
chamber lights
3. Press the
NOTE: This is optional . The machine will print without
the chamber lights on .
4. Ensure all doors are locked by verifying that the
is on. If not, press the System Enable
5. Verify the doors are locked by looking at the main Status Screen
on the UI. The green lock button should show
the doors are locked. If not, press this button to lock the doors
(5).

Home the Elevator

If the printer was not already turned on:
1. Select Tools from the main screen (6).
2. Select Elevator/Leveler
Move to Home
3. Select (8).
7
3D Systems, Inc.
18.
icon (1) on the touchscreen to launch the
button (2).
System
(4) button.
Unlock Door
(7).
6
"Print Pad Installation" on page 60
"ProX 800
1
(3) light
if
ProX 800
8
56
for more
2 3 4
5