Table of Contents
Advertisement
21. Ship the following to 3D Systems Customer Support:
•
Calibration plate: use a shock-resistant package that protects the plate from damage. Make sure to indicate the
serial number of the corresponding printer on a paper labelled on the back of the calibration plate.
•
Current correction file: send an email to
indicating the serial number of the corresponding printer.
22. 3D Systems Customer Support will then give the result of the measurement:
•
If the result of the calibration is not correct, 3D Systems Customer Support will supply a new correction file (xml
format); proceed then to the next section.
•
If it is correct, the printer calibration is validated.
Import a new correction file
The following steps must be performed as long as the calibration has not been validated .
1.
Store the new correction file (xml format) supplied by 3D Systems Customer Support on a USB key.
2.
Install the USB key on the USB port (see "D. Screen control panel and external control panel" on page 27).
3.
Make sure to access to the control software by using the Adjuster level (see "User level selection" on page 47).
4.
Access to the
Configuration
5.
Go to the
Optic
menu (1).
6.
Click on the
Import
button (2).
7.
Select the new correction file, then validate. The new
correction will replace the previous one (confirm the
overwriting message if displayed).
8.
Draw a new calibration plate (see page 95).
9.
To control and validate the new calibration, ship the following to 3D Systems Customer Support:
•
Calibration plate: use a shock-resistant package that protects the plate from damage. Make sure to indicate the
serial number of the corresponding printer on a paper labelled on the back of the calibration plate.
•
Current correction file: send an email to
indicating the serial number of the corresponding printer.
10. 3D Systems Customer Support will then give the result of the measurement:
•
If the result of the calibration is not correct, 3D Systems Customer Support will supply a new correction file (xml
format); repeat steps from 1 to 10.
•
If it is correct, the printer calibration is validated.
COPYRIGHT AND TRADEMARK NOTICE
7
Copyright © 2016 3D Systems, Inc. All rights reserved. Subject to change without notice. This document is copyrighted and
contains proprietary information that is the property of 3D Systems, Inc. 3D Systems, the 3D Systems logo, and ProX are
trademarks of 3D Systems, Inc.
3D SYSTEMS, INC.
hotline.phenix@3dsystems.com
tool.
hotline.phenix@3dsystems.com
by attaching the correction file and
1
2
by attaching the correction file and
97
Advertisement
Table of Contents
