Optional Configuration - Paradyne 6512 Installation Instructions Manual

Superline adapter
Table of Contents

Advertisement

Optional Configuration

If your home or office phone jacks are wired internally with 4 wires (Pins 2, 3, 4, and 5),
you may be able to connect phones in other rooms to your SuperLine Adapter by using
optional hardware purchased from your local electronics or phone store. If you are
unsure if your home or office is wired with 4 wires, contact an electrician or your local
phone company.
Hardware Required (Supplied)
14-foot RJ11 phone cable.
Hardware Required (Not Supplied)
"T" type connectors. Refer to
connector specifications.
Second RJ11 phone cable.
Procedure
Use the following procedure and supporting figure to install your SuperLine Adapter
with multiple phones, faxes, or modems connected in other rooms.
In the Same Room as Your Adapter:
Plug a "T" type connector into the wall jack of the room where the adapter is
located.
Plug one end of the phone cable into the LINE jack on the adapter rear panel.
Plug the other end of the phone cable into Line 1 of the "T" type connector.
Plug a second phone cable (not supplied) to Line 2 of the "T" type connector.
Plug the other end of the second phone cable into the PHONE 1-2 jack on the
adapter rear panel.
NOTE:
Do not use a 4-wire phone cable to connect phones, faxes, or modems to the
PHONE 1-2 jack. A 4-wire phone cable connected to the PHONE 1-2 jack may
cause interference on phones, faxes, or modems connected to the PHONE 2 jack.
In Another Room:
Plug a second "T" type connector into the wall jack of another room.
Connect the additional phone to Line 2 of the "T" type connector. You can connect
a phone to your existing phone line using Line 1 of the "T" type connector as
shown.
Repeat Steps 6 and 7 for any additional rooms you want to connect.
Third Phone, Fax or Modem:
If applicable, connect a third phone, fax, or modem into the PHONE 2 jack on the
adapter rear panel.
To complete your SuperLine Adapter installation, refer to
Your Existing Phones
Technical Information
on page 17, and
Applying Power to the Unit
on page 23 for "T" type
Connecting Phone Filters to
18
on page 21.

Advertisement

Table of Contents
loading

Table of Contents