Displaying Csu Test Status - Paradyne 3150 Operator's Manual

Displaying CSU Test Status

Use the Test Status command to display the active tests
for the CSU. Status messages that can display on the front
panel LCD are listed in Table
To display test status,
1. From the top-level menu screen, select Stat.
2. From the Status screen, press the
TStat selection appears on the screen.
Message
No Test Active No tests are currently active.
LLB Test Active The network interface is in Line loopback.
PLB Test Active The network interface is in Payload loopback.
DLB Test Active The DTE port is in DTE loopback.
RLB Test Active The DTE port is in Repeater loopback.
QRSS on Net A QRSS test pattern is being sent on the network interface.
1–8 Test Active A 1-in-8 test pattern is being sent on the network interface.
Mon QRSS, Net A QRSS test pattern is being monitored on the network interface.
DLB Test, Extrn The DTE port is being held in DTE loopback by the external contact.
Lamp Test Active The Lamp test is currently active.
3150-A2-GB21-80
4-9.
key until the
Table 4-9
Test Status Messages
February 1998
3. Select TStat.
Status:
STest Perf
F1
The Test Status screen appears showing you what
tests are active for the CSU.
Description
Maintenance
TStat
F3
F2
4-21