Winder; Position Of The Winder Wheel In Long Arm Machines - Dürkopp Adler M-TYPE H867 Service Manual

Winder

15 Winder

15.1 Position of the winder wheel in long arm machines

Long arm Long arm machines have the winder in the center of the machine arm.
machines The winder wheel is therefore not aligned on the upper toothed belt wheel
in long arm machines, but rather on the driver wheel in the machine arm.
Correct setting
The distance between the winder wheel and the driver wheel is 0.8 mm.
Cover
• Arm cover (
Figure 51: Setting the distance between the winder wheel and driver wheel
(1) - Setscrews
(2) - Driver wheel
Setting steps
1. Loosen the two setscrews (1) on the driver wheel (2).
2. Move the driver wheel (2) to the right or left such that distance to the
3. Tighten the two setscrews (1) on the driver wheel (2).
Service manual H867 Version 00.0 - 08/2013
WARNING
Risk of injury
Switch off the sewing machine before setting the position of the
winder wheel.

Section 4.4.2 Removing and fitting the arm cover,
page 11)
winder wheel (3) is exactly 0.8 mm.
(3) - Winder wheel
65