Winder; Setting The Filling Quantity - Dürkopp Adler 650-10 Service Instructions Manual

Individual settings

3.25 Winder

3.25.1 Setting the filling quantity

Proper setting
After winding, ( Operating Instructions) the winding process stops auto-
matically if the bobbin is filled to approx. 0.5 mm under the edge of the
winder.
Fig. 43: Setting the winder filling quantity
(1) - Adjusting screw
(2) - Clamping screw
Rough setting
To roughly set the winder filling quantity:
1. Loosen the clamping screw (2).
2. Actuate lever (4) alignment:
3. Tighten the clamping screw (2).
Fine adjustment
To accurately set the winder filling quantity:
1. Loosen the adjusting screw (1).
2. Move the thread guide plate (3):
3. Tighten the adjusting screw (1).
Service Instructions 650-10 - 01.0 - 08/2016
NOTICE
Property damages due to winding without performing sewing!
When running without sewing material, sewing feet and the bobbin
capsule can be damaged in the hook.
Activate winder mode ( Operating Instructions, Manual Mode)
and take the bobbin capsule out of the hook when you run the test
winding process.
(3) - Thread guide plate
(4) - Actuating lever
• Move towards the bobbin = smaller filling quantity
• Move away from the bobbin = larger filling quantity
• Move towards the bobbin = smaller filling quantity
• Move away from the bobbin = larger filling quantity
53