HPE ProLiant DL345 Gen11 Service And Maintenance Manual page 69

Results Results
To replace the component, reverse the removal procedure.
Removing and replacing the SFF drive box blank Removing and replacing the SFF drive box blank
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
About this task About this task
CAUTION: CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays are populated with
either a component or a blank.
Procedure Procedure
1. If installed, remove the front bezel .
2. Power down the server.
3. If installed, open the cable management arm.
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Disconnect all peripheral cables from the server.
6. Remove the drive box blank:
a. Remove the drive box blank screws (callout 1).
b. Remove the drive box blank (callout 2).
HPE ProLiant DL345 Gen11 Server Service and Maintenance Guide 69