Table of Contents
Advertisement
7. Remove the access panel .
8. Do one of the following:
a. Remove the air baffle .
b. Remove the midplane drive cage .
9. Remove the rear 4 LFF drive cage .
10. Disconnect the boot device signal and power cables from the system board .
11. Remove the NS204i-u + secondary low-profile riser cage:
a. Release the half-turn spring latch (callouts 1 and 2).
b. Lift the riser cage off the system board (callout 3).
12. Disconnect the signal and power cables from the boot device.
13. Remove the boot device cage assembly:
a. Remove screws from the riser cage (callouts 1 and 2).
Retain the screws. These screws will be used to secure the new boot device cage assembly.
b. Pull the cage assembly from the slot (callout 3).
HPE ProLiant DL345 Gen11 Server Service and Maintenance Guide
183
Advertisement
Table of Contents
