Table of Contents
Advertisement
10. Close the retention frame:
a. When using a torque wrench to tighten the retention frame screw, set a torque between 1.24 N-m (11 lbf-in) to 1.47 N-m (13 lbf-in) .
b. Pivot the spring loaded retention frame downward and hold it down (callout 1).
c. Tighten the retention frame screw (callout 2).
11. If you are using the same heatsink, apply the full content of the thermal grease syringes on top of the processor. Follow the pattern
shown in the following image.
HPE ProLiant DL345 Gen11 Server Service and Maintenance Guide
242
Advertisement
Table of Contents
