HPE ProLiant DL345 Gen11 Service And Maintenance Manual page 184

14. Remove the boot device carrier:
a. Press and hold the carrier latch (callout 1).
b. Pivot the latch to open (callouts 2).
c. Slide the carrier out from the boot device cage (callout 3).
Results Results
To replace the component, reverse the removal procedure.
Removing and replacing the boot device cage assembly on top of the power supply cage Removing and replacing the boot device cage assembly on top of the power supply cage
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have the following items available:
T-15 Torx screwdriver
T-10 Torx screwdriver
Phillips No. 1 screwdriver
About this task About this task
CAUTION: CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
Procedure Procedure
1. Power down the server.
2. If installed, open the cable management arm.
HPE ProLiant DL345 Gen11 Server Service and Maintenance Guide 184