HPE ProLiant DL345 Gen11 Service And Maintenance Manual page 152

Results Results
To replace the component, reverse the removal procedure.
Optical drive replacement Optical drive replacement
Subtopics Subtopics
Removing and replacing the optical drive from the LFF chassis Removing and replacing the optical drive from the LFF chassis
Removing and replacing the optical drive from the SFF chassis Removing and replacing the optical drive from the SFF chassis
Removing and replacing the optical drive from the LFF chassis Removing and replacing the optical drive from the LFF chassis
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have the following items available:
T-10 Torx screwdriver
Phillips No. 1 screwdriver
Procedure Procedure
1. Power down the server.
2. If installed, open the cable management arm.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
HPE ProLiant DL345 Gen11 Server Service and Maintenance Guide 152