Table of Contents
Advertisement
Prerequisites
Prerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
About this task
About this task
CAUTION:
CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
CAUTION:
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all PCI slots have either a
riser slot blank or an expansion card installed.
Procedure
Procedure
1. Power down the server.
2. If installed, open the cable management arm.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel .
8. Disconnect any internal cables that are connected to the expansion card.
9. Remove the three-slot riser cage:
a. Loosen the captive screws (callouts 1).
b. Lift the riser cage off the system board (callout 2).
HPE ProLiant DL345 Gen11 Server Service and Maintenance Guide
129
Advertisement
Table of Contents
