Table of Contents
Advertisement
3. Close the retention frame:
a. When using a torque wrench to tighten the retention frame screw, set a torque between 1.24 N-m (11 lbf-in) to 1.47 N-m (13 lbf-in) .
b. Pivot the spring loaded retention frame downward and hold it down (callout 1).
c. Tighten the retention frame screw (callout 2).
4. If you are using the same heatsink, apply the full content of the thermal grease syringes on top of the processor. Follow the pattern
shown in the following image.
5. Install the heatsink:
CAUTION:
CAUTION:
To prevent mechanical damage or depositing oil on your hands or other contaminant to the heatsink contact surface,
hold the heatsink only by the edge of its base plate. Do not touch the heatsink fins.
HPE ProLiant DL345 Gen11 Server Service and Maintenance Guide
220
Advertisement
Table of Contents
