HPE ProLiant DL345 Gen11 Service And Maintenance Manual page 134

Results Results
To replace the component, reverse the removal procedure.
Removing and replacing the rack Removing and replacing the
Prerequisites Prerequisites
If you are replacing the rack mounting rails from a threaded-hole rack, make sure that you have a T-25 Torx screwdriver available.
About this task About this task
The illustrations used in this procedure show an icon on the upper right corner of the image. This icon indicates whether the action shown in
the image is for a round-hole, square-hole, or a threaded-hole rack.
Round-hole rack Square-hole rack
Procedure Procedure
1. Power down the server.
2. If installed, open the cable management arm.
rack rails rails
Threaded-hole rack
HPE ProLiant DL345 Gen11 Server Service and Maintenance Guide 134