HPE ProLiant DL345 Gen11 Service And Maintenance Manual page 52

Remove the fan cage Remove the fan cage
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure Procedure
1. Power down the server.
2. If installed, open the cable management arm.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel .
8. Remove the existing fans:
a. Press and hold the latch (callout 1).
b. Lift the fan from the fan cage (callout 2).
HPE ProLiant DL345 Gen11 Server Service and Maintenance Guide 52