HPE ProLiant DL345 Gen11 Service And Maintenance Manual page 193

Results Results
To replace the component, reverse the removal procedure.
Removing and replacing a boot device Removing and replacing a
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have the following items available:
Phillips No. 1 screwdriver
T-10 Torx screwdriver
About this task About this task
CAUTION: CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays are populated with
either a component or a blank.
CAUTION: CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
Procedure Procedure
1. Back up all server data.
2. Power down the server.
3. If installed, open the cable management arm.
boot device drive with a security cover installed drive with a security cover installed
HPE ProLiant DL345 Gen11 Server Service and Maintenance Guide 193