HPE ProLiant DL345 Gen11 Service And Maintenance Manual page 191

Removing and replacing a boot device Removing and replacing a
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a Phillips No. 1 screwdriver available.
About this task About this task
CAUTION: CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays are populated with
either a component or a blank.
CAUTION: CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
Procedure Procedure
1. Back up all server data.
2. If installed, open the cable management arm.
3. Remove the boot device carrier:
a. Press and hold the carrier latch (callout 1).
b. Pivot the latch to open (callout 2).
c. Slide the carrier out from the boot device cage (callout 3).
Boot device on the NS204i-u + secondary low-profile riser cage
boot device carrier without a security cover installed carrier without a security cover installed
HPE ProLiant DL345 Gen11 Server Service and Maintenance Guide 191