Table of Contents
Advertisement
11. If installed, disconnect all cables from boot device and expansion card.
12. Remove the expansion card:
a. Pivot the riser cage to vertical position.
b. Open the retention latch (callout 1).
c. Remove the expansion card screw (callout 2).
Retain the screw. The screw will be used to secure the new expansion card spare.
d. Remove the expansion card from the riser cage (callout 3).
Results
Results
To replace the component, reverse the removal procedure.
Removing and replacing an expansion card from three-slot primary/secondary riser cages
Removing and replacing an expansion card from three-slot primary/secondary riser cages
HPE ProLiant DL345 Gen11 Server Service and Maintenance Guide
128
Advertisement
Table of Contents
