Table of Contents
Advertisement
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel .
8. Do one of the following:
a. Remove the air baffle .
b. Remove the midplane drive cage .
9. If installed, remove the cable guards .
10. Remove the fan cage.
11. Disconnect the front I/O and USB cable from the system board .
12. Remove the right chassis ear assembly:
a. Remove front right chassis ear screws (callouts 1).
Retain all screws for future use.
b. Pull the right chassis ear and front I/O and USB cable (callout 2).
Results
Results
To replace the component, reverse the removal procedure.
Removing and replacing the left chassis ear
Removing and replacing the left chassis ear
Prerequisites
Prerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
HPE ProLiant DL345 Gen11 Server Service and Maintenance Guide
117
Advertisement
Table of Contents
