HPE ProLiant DL345 Gen11 Service And Maintenance Manual page 182

Removing and replacing a boot device carrier without a security cover installed Removing and replacing a boot device carrier without a security cover installed
Removing and replacing a boot device drive with a security cover installed Removing and replacing a boot device drive with a security cover installed
Removing and replacing a boot device drive without a security cover installed Removing and replacing a boot device drive without a security cover installed
Removing and replacing the boot device cage assembly from NS204i-u + low-profile riser Removing and replacing the boot device cage assembly from NS204i-u + low-profile riser
cage cage
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
About this task About this task
CAUTION: CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
Procedure Procedure
1. Power down the server.
2. If installed, open the cable management arm.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
HPE ProLiant DL345 Gen11 Server Service and Maintenance Guide 182