Table of Contents
Advertisement
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel .
8. If the rear 4 LFF drive cage is installed, remove it.
9. Remove the riser cage.
10. Remove the OCP slot blank:
a. Remove the blank screw (callout 1).
b. Use a plastic spudger to pry the top side of the blank from the chassis (callout 2).
c. Remove the blank (callout 3).
Retain the screw and blank for future use.
HPE ProLiant DL345 Gen11 Server Service and Maintenance Guide
133
Advertisement
Table of Contents
