HPE ProLiant DL345 Gen11 Service And Maintenance Manual page 261

Item Item Description Description
1 Slot 1 PCIe5 x16 stacking riser
2 Slot 2 PCIe5 x16 free-height riser
3 Slot 3 PCIe5 x16 base riser
4 Slot 4 PCIe5 x16 stacking riser
5 Slot 5 PCIe5 x16 stacking riser
6 Slot 6 PCIe5 x16 base riser
7 2 SFF stacked drives (optional)
8 NS204i-u boot device (optional)
9 Flexible Slot power supply 1
10 Flexible Slot power supply 2 (optional)
11 VGA port
12 Slot 22 OCP PCIe5 x8
13 Serial port (optional)
14 iLO management port
15 USB 3.2 Gen 1 ports
16 Slot 21 OCP PCIe5 x8
1
These riser slots are in a primary riser cage.
2
These riser slots are in a secondary riser cage.
3
The 2 SFF stacked drive cage option supports SAS, SATA, or U.3 NVMe drives.
4
In Slot 21 OCP, the OCP bandwidth upgrade cable is required to support an x16 OCP expansion option.
Subtopics Subtopics
Display device setup Display device setup
Display device setup Display device setup
This server supports both VGA port and DisplayPort 1.1a. Before connecting a display device to this server, review the information below.
Whenever possible, use the same display connection type. For example, if your PC or monitor only has a VGA output, connect it to the
server VGA port. Use of any kind of adapter or converter cable or dongle might lead to decreased display quality or a lag over the
connection.
DisplayPort connection: When connecting an HDMI or DVI display to the DisplayPort, use an active type adapter. Passive type adapter—
marked with the DP++ symbol—is not supported.
Display output modes:
If you connect two display devices to the VGA port and DisplayPort, the same image is shown on both devices—screen mirroring
mode.
The embedded video controller in the iLO 6 chipset does not support dual display or screen extension mode. To enable dual display
mode, install a compatible PCIe graphics card that supports this feature in the expansion slot.
Rear panel LEDs Rear panel LEDs
1
1
1
2
2
2
3
4
HPE ProLiant DL345 Gen11 Server Service and Maintenance Guide 261