Table of Contents
Advertisement
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel .
8. Remove the rear 4 LFF drive cage .
9. Disconnect any internal cables that are connected to the expansion card.
10. Remove the riser cage:
a. Release the half-turn spring latch (callouts 1 and 2).
b. Lift the riser cage off the system board (callout 3).
11. If an expansion card with internal cables is installed on the riser, disconnect the cables from the card.
12. Remove the expansion card:
a. Remove the screw (callout 1).
Retain the screw. The screw will be used to secure the new expansion card spare.
b. Press and hold the release latch (callout 2).
c. Detach the expansion card from the riser (callout 3).
HPE ProLiant DL345 Gen11 Server Service and Maintenance Guide
125
Advertisement
Table of Contents
