HPE ProLiant DL345 Gen11 Service And Maintenance Manual page 179

3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel .
8. If the server is in the rear 4 LFF drive configuration, remove the rear 4 LFF drive cage .
9. Remove the primary riser cage.
10. Unplug the USB device from the USB port.
Results Results
To replace the component, reverse the removal procedure.
Removing the boot device Removing the boot device security cover from the NS204i-u + secondary low-profile riser
cage cage
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
Procedure Procedure
1. Power down the server.
2. If installed, open the cable management arm.
security cover from the NS204i-u + secondary low-profile riser
HPE ProLiant DL345 Gen11 Server Service and Maintenance Guide 179