Table of Contents
Advertisement
2.
INSTALLATION
The 2405EO-HD is a compact module that has three BNC connectors and one SC/PC (shown), ST/PC or
FC/PC optical connector.
HD INPUT:
Input BNC connector for 10-bit serial digital video signals compatible with the SMPTE 292M
standard.
(19.4 Mb/s), SMPTE 259M (143 to 540 Mb/s) or DVB-ASI, or most other signals with bitrate
less than 1.5 Gb/s. See section 5.1 for information on operating the module in non-reclock
mode.
HD OUTPUT: There are two BNC connectors with reclocked serial component video outputs, compatible
with the SMPTE 292M standard. In non-reclock mode these outputs contain an equalized copy
of the input signal.
There is one SC/PC (shown), ST/PC or FC/PC female connector with reclocked serial
component video outputs, compatible with the SMPTE 292M standard. This connector is the
optical output from the 2405EO-HD as shown in section 3.3.
The 2405EO-HD comes with an auto-ranging DC voltage adapter that automatically senses the
input voltage. Power should be applied by connecting a 3-wire grounding type power supply
cord to the power entry module on the DC voltage adapter.
minimum 18 AWG wire size; type SST marked VW-1, maximum 2.5 m in length. The DC cable
of the voltage adapter should be connected to the DC power jack on the rear panel. A green
LED located beside the power connector will be illuminated when there is power applied to the
2405EO-HD.
2405EO-HD SMPTE292M Re-Clocking Electrical to Fiber Converter
Figure 2-1: 2405EO-HD Module
The 2405EO-HD can also be used in non-reclock mode with SMPTE 310M
2400 Series Fiber Converter Manual
Revision 1.3
The power cord should be
2405EO-HD-3
Advertisement
Table of Contents
