Installation - evertz 2405OE Instruction Manual

2400 Series Fiber Converter Manual
2405OE SMPTE 259M Re-Clocking Fiber to Electrical Converter
2.

INSTALLATION

The 2405EO is a compact module that has two BNC connectors and one SC/PC (shown), ST/PC or
FC/PC optical connector.
SDI 1 INPUT: This SC/PC (shown), ST/PC or FC/PC female optical connector is the primary input to the
2405OE, providing reclocking of serial digital signals at the specified rates. This wide range
input accepts optical wavelengths of 1310nm to 1610nm, accommodating standard or CWDM
transmission schemes.
SDI 2 INPUT: This BNC input provides a second Serial Video input. When the SOURCE DIP switches
are set to the AUTO mode, the module will switch to the coaxial input in case of optical link
failure. In addition either input may also be selected as the sole signal source. See section 5.2
for more information on setting the SOURCE DIP switches.
SDI OUTPUT: The 2405OE provides two coaxial outputs for signal distribution. These outputs will contain
the signal from either the optical or coaxial input depending on the settings of the SOURCE DIP
switches. Only the SDI OUTPUT closest to the SDI 1 INPUT connector maintains the correct
polarity for DVB-ASI signals.
The 2405OE comes with an auto-ranging DC voltage adapter that automatically senses the
input voltage. Power should be applied by connecting a 3-wire grounding type power supply
cord to the power entry module on the DC voltage adapter.
minimum 18 AWG wire size; type SST marked VW-1, maximum 2.5 m in length. The DC cable
of the voltage adapter should be connected to the DC power jack on the rear panel. A green
LED located beside the power connector will be illuminated when there is power applied to the
2405OE.
2405OE-2
Table 2-1: 2405OE Module
Revision 1.1
The power cord should be